Life was so much easier years ago when the rig went into the rig doctor and an extra block got added.
Now I'm playing with a computer within a rig.
So, before I make everything go PHUT!
I used a programming lead to back up the default settings.
(Dead proud of myself for managing to do that.)
The decision now is whether to enable Band 1 & 2.
Problem is I've got TWO ways of doing it.
(Thank you YouTube for confusing me).
So, being a scaredy cat when it comes to anything computerized, I'm asking is this is the correct set of instructions??
CRT SS 6900 V6
PRESS AND HOLD FUNC + S/RF
TURN ON RADIO
INDICATED AS 1BAND
TURN CHANNEL SWITCH TO 2BAND
PRESS FUNC UNTIL RES THEN REND SHOWS ON SCREEN
TURN OFF, TURN ON, JOB DONE??